15 Years Factory wholesale SQUARE BAR for Victoria Factory

The F-13-C is a production machine that bends flanges on flat-, conical- and domed ends for cisterns, tanks and other similar components.
It has a maximum capacity of 13 milimeters in mild steel and can also be utilized for materials such as stainless steel, acid proof steel, aluminium and copper.

It only takes 3-5 minutes to form a flange with a 50 milimeter radius on a tank end of 12 milimeter thick plate and 2 meter diameter, therefore it is a very rapid and efficient machine.
Thanks to the flexibility and simplicity of the machine, an unskilled operator can use it and receive perfect results!

For more information, please contact us at info@roundo.com

www.roundo.com

From https://www.kevincaron.com/ – Artist Kevin Caron uses the wrong tool for the right reasons ….

Caron is creating a sculpture for which he needs a 70″ ring made of 1/2″ solid round stock – he’s drawn an outline of the ring on his rising workbench. He decided to use his pipe roller to make the ring, but someone asked why he was using a pipe roller to roll solid metal rod when he has a stock bender (also known as a Chinese pipe bender), which is what you usually use for this job.

He shows a section of the 1/2″ metal rod he is using. Next Caron show one of the rollers from the stock bender. Because the roller is flat, if he uses the stock bender, the bend can become jerky and the whole ring might be wavy, rather than flat. Caron bends the small section of rod to show what can go wrong.

So Caron gets out his pipe bender. He shows one of the pipe bender’s stock rollers, and how it cradles the pipe, which stays within its channel. If you try to put something too small in that kind of die, though, you’re going to create ripples instead of the metal coming out perfectly round and straight.

He doesn’t have a roller small enough to fit the 1/2″ rod, but he does have a square roller for working with square hollow metal stock or square solid stock that’s close enough in size to fit the 1/2″ rod. So he can run the round stock through the square die and it will still come out straight, as he demonstrates.

So that’s why he’s using the wrong machine with the wrong dies to do the job – because that’s what he has on hand, and it will actually do the job.

Now it’s time for Caron to go back to work. We get to see a photo of how he used the ring for his sculpture Portal ( http:;//www.kevincaron.com/art_detail/portal.html ). The sculpture will look a lot different when it is completed – the ring will be one of the things that will disappear. While you’re on Caron’s site, you can see hundreds more how-to videos and Caron’s other wild work.