Factory Outlets STEEL PLATE for Amman Manufacturer
Short Description:
From 30 x 25 mm to 2.000 x 600 mm (in case of a smaller width correspondingly thicker)
Factory Outlets STEEL PLATE for Amman Manufacturer Detail:
From 30 x 25 mm to 2.000 x 600 mm
(in case of a smaller width correspondingly thicker)
Product detail pictures:
Factory Outlets STEEL PLATE for Amman Manufacturer, The product will supply to all over the world, such as: , , ,
The fill wire is easily attached to the marred surfaces of the copper components to fill in gaps and smooth out valleys. Electrode placement is important in getting the correct flow of the metal to the areas desired. Initial experimentation shows that an energy setting of 22ws in Micro Mode will attach the fill wire without deformation of the component at the weld site. Multiple pulses are used to flow the wire along the scar and then welds at a higher energy (100ws) are used to smooth the area and level it out.
For the hardened steel component we attached the wire to the part using “Tack Mode” set at 50ws energy prior to the pre-heat process. After pre-heating the part at 400 degrees with the fill wire tacked on, we used the Orion Pulse 200i to complete the welding process with several pulses at 22ws energy followed by actuations at 120ws energy to smooth.
here in this lecture we will be learning in detail steel calculation for RCC slabs. and this quit simple. we will just calculate length of all steel bars and then the weight is simple using formula.
thanks for watching.
By from -
By from -