https://classiccarbs.co.uk/
Gentlemen,
Video Description:
2.2ltr ford sohc ‘pinto’ engine
offset ground crank, diesel rods, cologne v6 cast alloy pistons, teflon buttons, Burton power rings, stainless steel one-piece inlet & ex., valves (44.5 & 38mm respectively – wasted stems and inlet seat further narrowed).
Epoxy resin used to improve shape of inlet port – ‘Apple port’ as per David Vizzard book specs.
Carburettors:
2x Twin 45mm Dellorto DHLAs with (If I remember correctly) 38mm Chokes.
Infact, the specs I followed are available in Des Hammill’s book ‘How To Power Tune Ford SOHC ‘PINTO’ Engines. He gives several examples of motors including 2-3 set-ups for Pinto engines including 2100cc which is the one I used. It got the results you see above.
Cylinder Head work has been elaborate and very time consuming (Valve guides have been ground flush with the roof on both inlet and exhaust ports).
Exhaust ports enlarged throughout. -
Both in. & ex. throts have neen ‘throated’ and then blended in upstream with the rest of the port.
Heavy duty bearings all around including camshaft.
Standard ford factory camshaft & springs used during this video.
Standard points type distributor etc etc..
Mechanical Compression approx 10.8:1 (I used 100octane shell V-power petrol for my runs).
Standard flywheel had all the available mass machined off to give the lightest possible unit whilst retaining most of the strength. It has five steel dowel + 6x ARP bolts fastening it to the crank.
Crank was machined at halesowen engines (Don’t think they do it anymore as old man retired) then heat treated at laystall crankshafts in Wolverhampton (different trading name now I think) and also polished at laystall crankshafts.
Diesel rods have seen some machining to get them to fit the crankshaft (Rods are thicker and longer + a little hevier when standard).
Rods fitted with ARP YB cosworth rod bolts (No nuts).
I spent the best part of 7 years building this engine.
It has been a financial disaster and I would not do it again.
Saying that however, the value of building and running the engine successfully will most likely reveal itself as the years go by.
I’m pleased you like the video and wish you great results with your project!
(Dedicated to my uncle Robin).
Thanks for watching
Emmanuel Grigoriou
https://classiccarbs.co.uk
2005-2013 Stourbridge (UK)
Thank you. 
P.s.
WEBER DCOE/DELLORTO DHLA Twin 40s/45s/48s
We supply Brand New, Genuine WEBER DCOE Twin Carburettors tuned for your Classic Ford Engine – ready to start & use.
We also stock Mangoletsi Four branch Inlet manifolds, mounting kits, air filters, fuel pumps, throttle linkages and more..
visit our shop: https://stores.ebay.co.uk/25Starsailor
Or contact us at : support@classiccarbs.com
Thanks for watching!!
Emmanuel Grigoriou
Classiccarbs.co.uk
Post time: Oct-14-2017